Commercial Heating Season Checklist for Cincinnati Facility Managers
In Cincinnati, the normal first freeze arrives around October 25, according to the National Weather Service. By early November, heat is running in most commercial buildings across Greater Cincinnati and Northern Kentucky, and the first real cold snap is when problems that built up over the summer show themselves.
Gas heat sections on rooftop units sit idle for five or six months. Boilers get switched back on. Economizer dampers that worked fine in mild weather start letting in air that can freeze a coil overnight. Catching these issues during a planned visit costs far less than finding them on a 15-degree Monday morning with tenants calling.
Here is the checklist our service technicians work through when we bring a commercial building over to heating.

Rooftop Units with Gas Heat
- Inspect the heat exchanger for cracks, holes and corrosion. A cracked heat exchanger can let combustion gases into the airstream.
- Test ignition, flame sensing and every safety: high limit, rollout switches and the draft inducer pressure switch.
- Check gas pressure against the manufacturer's rating and confirm the flue and combustion air paths are clear.
- Replace filters and check belts, bearings and blower operation.
- Verify economizer dampers close fully when the building is unoccupied and hold the correct minimum outside air when it is occupied.
Boilers and Hydronic Systems
- Run a combustion analysis and tune the burner.
- Test the low-water cutoff and the pressure relief valve.
- Check the expansion tank charge, circulating pumps and water treatment.
- Look for leaks at valves, fittings and coils before the system is under full load.
Make-Up Air and Exhaust
Kitchens, warehouses and manufacturing spaces depend on make-up air units to keep pressure balanced. When the burner on a make-up air unit fails, doors get hard to open, kitchen hoods stop drawing properly and cold air pulls in through every gap. Check burner operation, airflow and the controls that tie make-up air to exhaust fans.
Heat Pumps and Split Systems
Confirm the defrost cycle works and that backup electric heat comes on when it should. A heat pump stuck in defrost, or relying on strip heat all winter, shows up later as a high utility bill.
Controls and Schedules
- Set occupied, unoccupied and holiday schedules for the season. Thanksgiving through New Year's is when buildings sit empty with the heat running.
- Check space sensors and outdoor air sensors against a reference reading.
- Make sure building automation alarms reach someone who will act on them.
Freeze Protection
Freeze damage is the most expensive winter call we see, because it is rarely just one repair. Water coils in air handlers, outdoor piping, cooling towers and condensate lines are the usual weak points.
- Confirm freeze stats are working and wired to shut down outside air.
- Test glycol concentration in systems that use it.
- Check heat trace on exposed piping.
- Drain and winterize cooling towers and any outdoor equipment not needed in winter.
Signs You Should Call Now
- A burning smell that lasts more than the first few minutes of operation
- Units that short cycle or lock out on safeties
- Cold areas of the building that were comfortable last winter
- Water on the floor near air handlers or boilers
If a carbon monoxide detector goes off, get everyone out of the building first and call 911 or your gas utility. Then call your service contractor.
Where This Fits in a Maintenance Program
A fall heating inspection is half of a good preventive maintenance program. The spring visit covers cooling. Together they let us find small problems while they are still small and give you a record of every unit's condition, which matters when you build next year's budget. You can read more about how scheduled maintenance programs work.
Schedule Your Heating Inspection
Jarvis Mechanical's service team maintains commercial HVAC systems across Greater Cincinnati and Northern Kentucky, including offices, retail, warehouses, healthcare and municipal buildings. If your equipment has not had a fall inspection yet, request a service visit or call us at 513.831.0055.
Learn more about our commercial service and maintenance programs
Jarvis Mechanical Service Team